iPad (Type:A)

iPad (Type:A)

How to wrap?

First, be sure to wipe the unit clean with the cleaning wipe provided.

If you apply the skin sticker with dirt remaining, it will peel off easily.


Attach the side skin stickers in the order of (1) to (4) in the figure below. If you are using the Cellular model, please remove the SIM slot skin sticker.


Attach the skin sticker on the back camera area and peel off the excess skin sticker from the backing paper. Next, peel off the skin sticker from the main unit and place it upside down. Remove the Apple logo part by pushing it out, and then shift the backing paper and reattach it from the top as shown in the figure below. Please note that it is not possible to remove only the Apple logo part after it has been applied to the device.


Align and apply the skin sticker around the rear camera and the connection terminals (orange areas). Pull out the backing paper and apply the entire skin sticker, then rub the skin sticker firmly to press it into place. Avoid aligning the skin seal with the Apple logo, as this will result in misalignment. Also, when peeling off the skin seal to reapply before crimping, be careful of the direction in which you peel off the skin seal, as it may tear from the edge of the Apple logo.