How to wrap?
First, be sure to wipe the unit clean with the cleaning wipe provided.
If you apply the skin sticker with dirt remaining, it will peel off easily.
<In case you use Surface GO series
Please understand in advance that the orange color part may peel off the paint of the device itself when you peel off the skin sticker.
-Surface Go1 and Surface Pro4/5/6
Surface Go1 and Surface Pro4/5/6 do not have the logo cut out.
- Surface Go1 and Surface Pro4/5/6 do not have the logo cut out.
Surface ProX and Pro8 do not come with side parts, only the back.
Remove the excess skin sticker from the backing paper. Next, peel off the skin sticker from the top of the device, turn it inside out, and reposition it slightly from the backing paper as shown in the illustration. Align the pink areas and stick it. Pull out the backing paper and apply the entire skin sticker, then rub the skin sticker firmly to press the skin sticker into place.
Remove the skin sticker from the logo mark area. Next, peel off the skin sticker from the lower part of the main unit, place it upside down, and reattach it from the top by shifting the backing paper as shown in the illustration. Align the skin sticker with the center crease (orange part) and paste it. Pull out the backing paper and apply the entire skin seal, then firmly rub the skin seal to press it into place. Avoid aligning the skin seal with the logo mark, as this will result in misalignment.
Attach the side skin stickers in the order of (1) to (3) in the figure below. If the skin sticker is floating, apply warm air from a hair dryer to firmly adhere the skin sticker. Surface Pro8 and ProX do not come with side skin stickers.