Attach the skin sticker to the camera area.

Remove the skin sticker from the main unit, place it upside down, and remove the logo mark part. Since it is pre-cut, it can be removed by pressing it with a thin, sharp object. Please note that it is not possible to remove only the logo part after it has been attached to the device.

After aligning the camera with the straight sections at the top and bottom (orange areas), paste the camera so that the gap between the left and right sides (pink areas) is even. Leave the side portions floating when attaching.

Warm the side part (orange part) firmly with warm air from a hair dryer, and when the skin seal is soft enough, apply it along the side. Insufficient warmth may cause lifting or wrinkling. In this case, please warm up the skin sticker again and reapply it. Leave the four corners (pink areas) floating without attaching.

After all the side parts have been applied, warm the four corners of the back side (orange areas) firmly with warm air from a hair dryer, and when the skin sticker is soft enough, attach it by rubbing in the order of (1) to (3). Next, warm the four corners of the side side (pink areas) and attach the skin stickers. At this point, be careful not to pull on the skin seal as it will stretch. Insufficient warmth may cause lifting or wrinkling. In this case, please warm up the skin seal again and reattach it.

Align the camera with the straight sections at the top and bottom, and then attach the camera so that the gap between the left and right sides is even.

Keep the area around the skin seal (orange area) floating when attaching, warm the skin seal firmly with warm air from a hair dryer, and when the skin seal is soft enough, rub and press the skin seal in the order from (1) to (3). If the skin seal is not sufficiently warmed, it may float or wrinkle. In this case, please warm up the skin seal again and reattach it.